9 replies
by dmiles
You can try adjusting the swap file size to not sacrafice system performance.
Then you may try running chkdisk from MSDOS program as an alternative.
by lvollmer
by gathel
by lvollmer
by mmccaskill69
If you have the full 27 GB as one partition or if you have partitions larger than 8 GB, then scandisk will be unable to run.
Reason is that Scandisk does not recognize the cluster size.
If your HDD is setup like this then a third party HDD tool was used to partition the HDD.
The way to fix the problem is to contact the manufacturer of the Third-party HDD tool for a possible update to fix the issue.
If the drive was created with partitions 8 GB or smaller, then I would do the above mentionedand free up some conventional memory.
Good Luck!
by lvollmer
by cosloot
I just scanned my Seagate 20 GB drive and it is all one partition. Are you clicking 'start', 'programs', 'accessories', 'system tools' and then click on 'Scandisk'?
It almost sounds like you are running scandisk for a Fat16 drive instead of scandisk for a Fat32 drive. Run it from inside windows and not from DOS. Soul Rider is correct that you can type chkdsk.exe at a protected DOS prompt and still run the checkdisk program which was the precursor to scandisk utility. Both work on my 20GB,Thanks Soulrider I thought that program was gone with 98.
by lvollmer
by lvollmer
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending