Setting up DHCP Server
I have a small network running NT 4.0 sp4.
How do I set up my server to become a DHCP server and assign TCP/IP Address etc.? Thanks
Windows Forum
I have a small network running NT 4.0 sp4.
How do I set up my server to become a DHCP server and assign TCP/IP Address etc.? Thanks
by mmohammed
Right Click on Network Neighbourhood and go to properties. And Click on services Tab, Click Add and select Microsoft DHCP server and follow the prompts.
Thanks,
by morriss1
by azizhakim
1)YOU NEED TO INSTALL DHCP SERVER-GO TO CONTROL PANEL, NETWORK,SERVICES &ADD DHCP.YOU SHOULD SEE DHCP WITH OTHER SERVICES
LIKE WINS,RAS etc.THE DHCP SERVER MUST HAVE A STATIC IP NUMBER .RESTART PC,DHCP MANAGER IS CREATED IN YOUR ADMINISTRATIVE TOOLS.OPEN DHCP MANAGER,YOU NEED TO CREATE A SCOPE FROM
THE IP ADDRESSES GIVEN BY YOUR ISP WITH THE SERVER IP NUMBER YOUR START IP TILL THE END OF SCOPE.SELECT UNLIMITED FOR DURATION & O.K. TO ACTIVATE SCOPE &YOU ARE RUNNING.YOU THEN INSTALL THE CLIENTSIN NETWORK SERVICES,PROTOCOLS &TCP/IP PROPERTIES & CHECK
"OBTAIN IP ADDRESS FROM DHCP SERVER".YOU CAN PING YOUR SERVER IP TO CONFIRM CONNECTIVITY
-----REGARDS--HOPE IT HELPS--
by morriss1
by azizhakim
1)YOU NEED TO INSTALL DHCP SERVER-GO TO CONTROL PANEL, NETWORK,SERVICES &ADD DHCP.YOU SHOULD SEE DHCP WITH OTHER SERVICES
LIKE WINS,RAS etc.THE DHCP SERVER MUST HAVE A STATIC IP NUMBER .RESTART PC,DHCP MANAGER IS CREATED IN YOUR ADMINISTRATIVE TOOLS.OPEN DHCP MANAGER,YOU NEED TO CREATE A SCOPE FROM
THE IP ADDRESSES GIVEN BY YOUR ISP WITH THE SERVER IP NUMBER YOUR START IP TILL THE END OF SCOPE.SELECT UNLIMITED FOR DURATION & O.K. TO ACTIVATE SCOPE &YOU ARE RUNNING.YOU THEN INSTALL THE CLIENTSIN NETWORK SERVICES,PROTOCOLS &TCP/IP PROPERTIES & CHECK
"OBTAIN IP ADDRESS FROM DHCP SERVER".YOU CAN PING YOUR SERVER IP TO CONFIRM CONNECTIVITY
-----REGARDS--HOPE IT HELPS--
by morriss1
by mckaytech
First, (as in the other answers)add MS DHCP Server as a network service, configure your server with a static address and load DHCP Manager.
Within DHCP Manager, there are really just three things to set up initially: the range of IP addresses tobe assigned, the gateway address of the network (called "router option 003) which will be either the server if you don't have an external connection on the network or the router if you do, and the address of the name server (DNS or WINS or both). Other parameters will work fine with the defaults.
To make sure it's working properly, boot up a workstation set for DHCP and once it has booted up completely, go to a command prompt and type "ipconfig /all". Review the settings and see if they look okay. If so, you're done.
paul
by morriss1
by curlergirl
by morriss1
by jacky chin
1st. before get this DHCP server install, you need to identify all the workstations' IP addresses and of course those devices that connected to the network with TCP/IP protocol running need to be defined as well.
2nd. now only you can start to install your DHCP server from Control Panel - Network applet. But do remember to reapply your NT service pack after the installation.
3rd. define your scope of the IP address range and exclude those IP addresses that you've got from the 1st. step.
4th.then you can add in more things like the '003 default gateway' and etc.
Let me know for any problems. Good luck.
by morriss1
by morriss1
This discussion is closed to new replies.
Sort by Trending