Discussion Locked

Setup/Install 98SE - Protection Errors

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Dell Pent II - 4g hd. 98 Installs from CD - after reboot it does/will not go into completion setup - Gives me Protection Error and reboots. Any assistance would be appreciated.

4 replies

by funinalaska

Ah, just had a similar problem. Go to Microsoft Support, Under Windows98, install problems category there are instructions to fix this problem. Make sure you write down the Protection Error completely because they are listed by exact phrasing.
Good Luck, Kim

by pierrejamme

Win98SE install from a CD boot will almost always give you this. You need a Startup disk. Boot from the floppy then run setup from the CD.

by flying_dude

Had the same problem a few months ago. If I remember right, the following is what I did that got rid of that windows protection error.

repartition the HD, updated the bios, unplug most of the expansion card leave the necessary one(s). I think I had a v-card and a s-card in only. Re-installed with our any extra plug-ins. Runs ok, then have the rest up one by one.

I know its a pain, but might wanna give it a try.

by tofccn2003

QUESTION? DO YOU HAVE A WIN98 STARTUP DISK, MAINLY
A 3 1/2" FLOPPY DISK TO BOOT YOUR SYSTEM FROM? One
essential for installing a WINDOWS os, especially!
onto a hard drive with no os currently present, an
obviously unformatted hard drive, is the abilities
to format and partition the hard drive. WIN98 WILL
format and partition any drive under 8.5 gigabyte!
WITHOUT any need for a bios bypass utility such as
EZDrive.exe from Western Digital and like patches!
by other manufacturers. First, depending on setup!
of the bios itself to detect and boot from a drive
configured as "DRIVE 0" or "FLOPPY", depending on?
the order of sequence you have selected, once that
drive is "SYSED", or in other terms has systemized
by the transfer of system files to the root of the
"C:\" directory, the bios setup automatically see!
that the "PRIMARY" drive is there. IF? you haven't
looked into the bios settings from the start, that
drive may not be enabled in order to boot from! It
is the first requisite for any newly acquired pc?!
If there was an os already on the drive, such as a
NT based os, you may be better off using the FDISK
utility to elimate that os completely leaving that
possibly unaccessable drive now blank. From there,
proceed to format and "SYS C" as it would go. From
there upon bootup, you will see the command prompt
at the root directory. With MSCDEX.exe working, it
will be a simple task to run setup again for WIN98
to have a fresh install. You can then choose if or
not you want one or more partitions. The rest will
go normally. But, if you already have a working os
installed, backup any essential files before this!

This discussion is closed to new replies.