Question Locked

Slave drive problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello everybody im new to this website and i have a question regarding a hard drive. Up until recently both of the hard drives that i have worked fine. It is only after i cleaned the computer with compressed air that ive enountered a problem. When i hook up both master and slave drives the message pops up on the screen which says that operating system cannot be detected. When i hook up only the master drive it boots up fine. I am wondering if the slave hard drive is broken or do i need to run some set up. Your help would be appreciated.

Thank you

5 replies

by captbilly1eye

Look at the back of the slave HD. Make sure the small plastic jumper is present and positioned properly.
Your symptom makes me think it's not.

The correct positioning for the jumper can often be found on the HD's top label. Otherwise, you may need to check on the manufacturer's support web site under Documentation.

Hope this helps.

by magicx_06

Yes its present and it is positioned correctly according to the graph on top of the HD.

by captbilly1eye

The message you are getting when the secondary drive is connected, indicates the system is trying to boot from that drive rather than the primary drive. That situation would most likely be related to an incorrect connection or setting.

You may want to check the HD settings in the system BIOS. Although I doubt that just cleaning the inside of the case would have made changes to it, it's still worth checking.
Enter the BIOS settings (hitting F1 or Delete while booting) and set your Bios to boot to CDROM, Floppy, HDD 0, and see what happens.

If the boot order is set to that, and the jumpers are correct on both drives (one set to Master and the other set to Slave),the next step would be to replace the IDE ribbon cable.
I am assuming that you have the two drives connected to the board using the same single IDE cable.

by magicx_06

I went into BIOS and selected the secondary slave drive option. There i changed setting from AUTO option to CD-ROM. I restarted computer and the system booted up! I went into my computer and there i saw HDD which means that windows can detect it now. I went back to BIOS again and i set everything to defaults. It works great now!! Only thing i've noticed is that all the files that were installed are gone and that the path of the disk was changed from (F:) to (G:). In any case i really appreciate all your help. Thank you so much.

This discussion is closed to new replies.