4 replies
by djit463 Accepted solution
by robo_dev Accepted solution
If you're talking about really monitoring/troubleshooting at the physical layer, then you either need a T1 CSU/DSU that has built-in monitoring capabilities, or deploy a T1 Tap to allow monitoring to happen in another device. There's a ton of capability built into the Cisco gear, of course.
In terms of true low-level analysis, using a T1 Tap and a Fluke Optiview box or a Network Instruments Observer box...those will tell you everything, period.
http://www.networkinstruments.com/products/observer/wan.html
http://www.flukenetworks.com/products
Of course with Cisco products like the NAM module and the built-in features, you can probably do about 75% of what you need to do under normal circumstances.
by spitfire_sysop Accepted solution
by robo_dev Accepted solution
The practical issue is that if you are looking at issues at layer 3, and it's a layer 1 problem, you then have to get to the layer 1 level, and if you don't have that capability in place, then it takes valuable time to set that up.
The Cisco NAM (network analysis module) is essentially the same thing as a WireShark box on a card, except that you don't need to run cables, since the NAM is connected to the backplane of the switch or router, and you just mirror a port to it.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending