Windows Forum

Ask something
Discussion Locked

troubleshooting

0 helpful
7 replies

by babette 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

this error message comes up everytime i reboot

"Your networkadapter Linksys LNE100TX Fast Ethernet Adapter (0001) is not working properly. You may need to set it up again. For more information, see the Network Troubleshooter in Windows Help"

I have gone to Windows Help but the solution i found there did not help.
How else can i get rid of the message? Everything is working fine but just a nuisance to press "OK" all the time to continue.

7 replies

by mystic

Note be sure to write down ALL network settings in network neighborhood BEFOre anything else especially any assigned IP addresses then try removing the driver from the system, power off remove the card from the system, reboot download the latest drivers for the network card and then power off re install the card and reboot. On autodetect, give location of new drivers and this should correct the problem. Second question are you on a network? if not the card is useless in the system at present then remove it after uninstalling the drivers and store in a safe place.

by cajundon

Hi, Click on My Computer icon, click on Control Panel icon, and click on System icon. In System Properties click on the Device Manager tab. This show all the devices you have running on your system. Check to see if you have any devices with a yellow? or ! mark. If you do highlight each one and click remove. Then reboot your computer, and the drivers will be reinstall for you devices. Go back to Device Manager and see if they were install properly.

Good luck and have a great day.

Don Thibodaux, Computer Technology Consultant.

by babette

thank you for all the help. I downloaded a file from Linksys site to correct this.

This discussion is closed to new replies.