Discussion Locked

USB Support

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I know that there are third party solutions to the problem of no USB support for Microsoft NT. However, I could not find any device that would support digital cameras. Is there such a solution available? It should be in the less-than-$40-range, since anything much over that would suggest I just upgrade the operating system.

2 replies

by timwalsh

All the third-party solutions I've seen are in the form of a hardware vendor creating special drivers for their specific hardware (i.e. IOMEGA).

So unless you can find a digital camera vendor that supplies NT USB-support drivers for its cameras, you're probably out of luck.

by thechas

This is a link to the software firm that makes the NT uSB solution.

http://tinyurl.com/6oj2

They do state that they do NOT support digital cameras.

If there is no other option than USB for your camera, I see no choice but to upgrade to either W2K or XP.

If you decide to upgrade, you need to closely check ALL of your hardware for compatibility.

My rule of thumb, is if the hardware manufacture provides an XP driver.

There is a tool to check XP compatibility at www.pcpitstop.com
Additionally, you may find it cheaper to purchase an OEM version of W2K or XP from a computer reseller such as www.newegg.com rather than buying the retail upgrade version.
To satisfy the hardware purchase requirement for the OEM version, buy a new hard drive, or additional RAM for your system.

Chas

This discussion is closed to new replies.