Discussion Locked

Windows 2000 backup runs too slowly

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We are trying to use Windows 2000 backup (Ntbackup.exe) to do an online backup of a remote Exchange 5.5 server, backing up to a DLT tape. When we run this backup on an NT server, it runs very quickly. When we try to do the same on a W2K server, it is extremely slow and says that it will take over 1 day to back up. We have tried backing up other files on remote servers also, to eliminate it being strictly an Exchange problem, and everything we try to backup remotely using Windows 2000 is s...l...o...w. We'd like to get off of the NT server, but cannot find what is causing this! Any ideas would be appreciated!

2 replies

by p. dickason, cne, mcse, cca

Hi,
First I would get on the latest service pack of Win2k. Then I would check your networking equipment. It sounds like something might have a 10mbps connection instead of 100mbps. Your server conection might have 100mbps connection to the hub or switch but if that hub only connects at 10mbps to another hub, thats the bottleneck. Also ensure your getting a full duplex connection if your connected to a switch. Are you traversing a router? That would slow things down if your 2000 server was on a test network seperate than your production one. Hope this helps.
Pete

by tazz_nl

We had a similar problem with our backup.
It turned out to be a network problem.
The switch port and the servers NIC were configured to autodetect network speed and duplex mode. When we configured the switch port and the NIC to fixed 100MB/Full Duplex our backup finished within a few hours instead of 14-16 hours.

Hope this helps, good luck.

This discussion is closed to new replies.