Discussion Locked

Windows 95 & DHCP a no go

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
DHCP dows not seem to work in windows 95. I have an older Compaq Laptop (Armada 1560DM 32MB RAM) that I want to use as a terminal in my home network but DHCP (or maybe TCP/IP) fail to make a connetion with the router (Linksys. Or maybe I should try a version of Linnux that will run on 32MB of RAM?

7 replies

by superkknd

make sure you set your gateway points to your DSL/cable modem Router and use DHCP. My PC with windows 95 works well with Linsys 4 ports router.
my router ip is 192.168.1.1

by manshms

Tried this and the address shows up on ipconfig but the browser never makes a connection.

by r. a. caluste

if the dhcp server is from behind the router, make sure you enable bootp forwarding in your router so when that dhcp clients issue a broadcast request (DhcpDiscover), it can pass through the router and to the dhcp server. if the router is not bootp forwarding enabled, the dhcp server client's request for an ip address stops at the router and never reaches the dhcp server.

by wlbowers

Manually assign a tcp/ip address, the subnet mask and gateway and let it run. You don't have to use DCHP. If you have 3 computers pick a number 10 higher. Like 192.168.1.120

Subnet should be 255.255.255.0

Unless you have changed the linksys the gateway should be 192.168.1.1

Good Luck Lee

This discussion is closed to new replies.