Discussion Locked

Windows NT installation on an Extended P

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to install Windows NT server on Compaq server with 512MB RAM, RAID 5(3 x 36GB HDD). I need to install an application which has below requirements.

You must create the server partitions in the following order and to the following speccifications. The C drive must be configured as a Primary Partition and any subsequent partitions must be configured as Logical drives within Extended partitions.

First partition

for the co-resident client software disk partition letter must be C
minimum size of 1 Gbyte
system type of FAT or NTFS
must be located on disk 0
must be configured as a Primary Partition

Second partition

for the server software and operating system (Windows
NT 4.0)
disk partition letter must be D
minimum size of 4 Gbytes
system type of NTFS
must be configured as a Logical drive within an Extended
partition

Kindly let me know the procedure for installing the above said configuration.

Thnx/regards
shekar

2 replies

by sgt_shultz

How many physical hard drives are in this system?
If just one, it should be disk 0.
Install NT. When you get to the disk partitioning part, do this in order:
create primary partition. size: 1GB (or more, up to 2GB) type FAT
(will be created as C:)
create extended partition, size: 4GB (or more)
create logical drive D: in this partition (you will be prompted)
Finish installing NT. you can verify the disk numbers, partition types and drive letters in Disk Administrator
Install on NT service pack 6a...hope this helps

by gigelul

- First of all you must use your CD or diskette with the RAID configurator software and boot the system from it (change in BIOS boot sequence).
- With this utility configure an array (depends on you if you will define one array with 3 HDDs or more arrays and if you will apply a mirror or stripe scheme)
- In this array create logical disks like you described
- Save, restart and boot from a DOS system diskette (I'm not sure if the DOS will see the HDDs)
- a:\format c: /s
- Restart and boot from WinNT CD
- When you will be prompt to chose the partition, chose the second partition.
- finish install

This discussion is closed to new replies.