16 replies
by xcabal12 Accepted solution
by rob kuhn Accepted solution
by xcabal12 Accepted solution
by rob kuhn Accepted solution
Do you have anything happening on that server at night? Virus scans, defrag job, backup job or some other scheduled task? Something that could perhaps not only be causing the server to bog down and/or perhaps cause a memory leak?
Is there anything running in the background?
by xcabal12 Accepted solution
by rob kuhn Accepted solution
It almost sounds like you're suffering from a DoS attack (Denial-of-Service).
I don't know how easy or hard it is for you to do but one thing you can try is changing the public IP address and see how it goes. If you go that route, I might suggest you change the internal IP address too just in case the DoS attacks are actually coming from the inside of your firewall.
But before you go through that aforementioned hassles, when connecting from the outside, do you have to establish a VPN connection first? Or do you just have the port open? If the later I would *strongly* suggest you close that port and put in a VPN connection. Even if it's just the Microsoft RAS/PPTP (it's real easy to setup and you can secure it).
by xcabal12 Accepted solution
by gdeangelis Accepted solution
by xcabal12 Accepted solution
by supm1ke Accepted solution
Have you tried adjusting the connection settings on the Remote Desktop software itself before connecting? You may want to at least adjust it to something other than a LAN Connection to save in the network draw.
Also, is this happening around the same time or does it vary?
by xcabal12 Accepted solution
by gdeangelis Accepted solution
by xcabal12 Accepted solution
by rob kuhn Accepted solution
Everyone who has replied have left some good basic suggestions to check out.
Since it sounds as if you have the RDP port open in your firewall, I would close that port immediately and put up some sort of VPN. As mentioned, the Microsoft RAS/PPTP is easy and can be setup fairly quickly.
Even if this doesn't clear up the problem, you would have at least secured, IMHO, a major security hole! :)
What is this server's role? In other words why do people RDP to it? Knowing the role of the server may help us isolate the problem even more.
by robo_dev Accepted solution
Indeed, there are brute force hacking tools like Tsgrinder and tscrack that can cause exactly the symptoms you describe.
Since it does not log more than three failed connection attempts, tsgrinder attempts two connections, then resets, two again, then resets.
Tsgrinder brute forces the administrator account, since it cannot be locked out for local logons. The TS logon process uses an encrypted channel so it cannot typically be spotted by an IDS system.
I would bet if you logged the IPs of inbound connection attempts you will see LOTS of attempts per second.
If nothing else, use some port other than 3389. Security through obscurity is better than no security
by xcabal12 Accepted solution
i have set up an external monitor setup to find out where the issue is. i have changed the ports for rdp, hopefully i will find out where the problem is.
i will post update once i have enough information.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending