Question Locked

Windows Stop Error 0x0000007b

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a bit of a conundrum that I need some help with. I recently upgraded a number of components (mobo, cpu, memory, vid card). After trying to boot my system up, I get stop error 0x0000007b.

Here's the tricky part. I have two hard drives and a DVD drive. Windows xp is installed on HD1, while Linux is installed on HD2. GRUB is installed as the boot manager on HD1. My new mobo only has one IDE channel, and I have 3 IDE devices. If I only plug in HD1 and the DVD drive, I get a GRUB error because it can't see the linux partition. If I plug just HD2, there is no MBR to load an OS from. I have a PCI/IDE controller, but until I get into windows, I can't install it.

I'm wondering how I might fix the MBR on HD1 (or completely rewrite it--that's fine too) without being able to access any part of the drive.

Any ideas?

2 replies

by ic-it

Wouldn't it work if you installed both drives? set them to CS with HD1 on the end and HD2 in the middle.
Have you tried it with the controller in place so that XP will recognize and load the drivers.
If that fails you could use the DVD and XP drive to boot from the XP CD.
Enter the Recovery Console.
fixmbr, fixboot, bootcfg /rebuild

This discussion is closed to new replies.