Just to get a clearer picture... what make and model of HD? How big is it?
Although not in a RAID config., is the drive a SATA or IDE drive?
Is there more than one HD involved?
You may want to reset the BIOS to the 'default' settings.
Even though SATA drives are not in a RAID configuration, a SATA drive connection typically requires it to be in RAID mode.
With an IDE drive, connect it to the end of the ribbon cable rather than the middle.
During the install, did it get as far as to ask if you wanted to format the drive(s)?
Or did you format them previously using a manufacturer utility disk?
Or did the error message come up right away?
Was there another OS (like Vista) previously installed?
If so, Boot from the XP CD and then delete and recreate the partition. That way, XP will make that partition the active partition.
If there is more than one drive involved, are the jumpers at the back of the drives set correctly?
Also with more than one, try disconnecting the secondary drive until after the install.
If only one, you can try it with the jumper removed.
one last thing for now...
look at this article from MS and make sure it does not apply:
http://tinyurl.com/ujl37