Networks

Ask something
Question Locked

wireless router to network

0 helpful
3 replies

by faithlove

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi we have a wireless network setup where a Cisco router is being used as the dhcp server.
I want to add another wireless router to this network. How do I program this router so that it will not issue out the default IP addresses of 192.168.1.xxx. The network is already using a IP of 10.1.1.xx range.I need help in getting this done so there won't be a conflict with the IP addresses please. Thanks

3 replies

by seanferd

instead of one of the other RFC1918 blocks.

Should be really straightforward. Two minutes of poking around the GUI or looking up the ios command should have you covered.

edit: Looks like you want commands like
(config)#ip dhcp pool pool
(dhcp-config)#network 10.x.x.x 255.x.x.x
(config)#ip dhcp excluded-address range if necessary

Ah, have a look at this as well:
http://articles.techrepublic.com.com/5100-10878_11-5690240.html

This discussion is closed to new replies.