10 replies
by cudmasters los Accepted solution
by cg it Accepted solution
your SDM should be able to direct syslog messages to a syslog server. if you configure syslog right, you'll see everthing going in and out the WAN interface on your 1800.
if you capture packets from your network card, your only seeing what goes through that network card [interface].
by seanferd Accepted solution
That's the "Who has" business.
Yes, Wireshark can only capture the traffic routed through the device which is running wireshark, on whatever interface you specify.
If you have it installed on a server, all the traffic running through the chosen interface on the server is logged. If all clients connect only to the server through that interface, then all traffic is logged.
by robo_dev Accepted solution
or use the port-mirroring commands on your ethernet switch to redirect and capture traffic.
But a hub is sooo much simpler.
by cudmasters los Accepted solution
not sure what you mean by who has. at least 1/2 of the traffic i see is that statement,who has 10.1.10.2 tell 10.1.10.5 but not alwas the same address, at least 20 diffrent ones
also, i saw where i an ip address was queing another computer by the netbios name, so i traced it, found out that the computer(ip) had the printers(netbios) installed as auto-(name). I know i need to turn the printer off from being broadcasted, but What i'm wondering is if that ip is queing that other computer, how am i seeing it, it's going thru may card too?
by cg it Accepted solution
by robo_dev Accepted solution
"on the wire" meaning in your broadcast domain.
On an ethernet switch, everything in the same VLAN is one broadcast domain.
It needs to be this way, or devices cannot find each other, so things like the Windows network neighborhood would not work, nor could you browse for a printer.
Note that since it's an Ethernet switch, you only see directed traffic to/from your workstation, but if you install a hub, you can monitor all directed traffic going in/out of all hub ports, which is useful for the Wireshark sniffer.
A wireless LAN works the same way as a hub, so one client can sniff the directed traffic of his/her neighbors.
by cg it Accepted solution
A switch breaks up a collision domain.Each switchport on a switch is a collision domain. A hub all ports belong to on big collision domain [and domains in this sense are NOT what Microsoft calls a domain or internet domains].
Routers breakup broadcast domains into smaller ones.
by robo_dev Accepted solution
by cg it Accepted solution
when there wasn't a lot of people on the network... certainly kept collisions to a minimum....
how about 10base2 ??? every once in a while I have to do a field call on 10base2 and basically find out if there's a break ... but that's at places that absolutely positively will not spend any money on anything for anything.....lol...and believe it or not they complain about the problems.....
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending