Discussion Locked

XP Home not connecting to switch

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to connect my XP Home laptop to my home 8 port switch which is connected to a service providers switch for wireless internet access.Connection is not recognised: msg in Network Connections Local Area Connections is "network cable unplugged". if I bypass the switch and connect the laptop straight through to the service provider it works fine. But I have 2 other laptops (XP Pro, MacOSX)and they all work ok through the switch. Any ideas?

4 replies

by tk

The solution sometimes lies in the sequence that the system identifies each device. Make a plan that consists of the power on sequence of each device connected. Exp: Power XP , power service provider then power the switch. The answer could be any of the combinations. It all depends on the design of each device.

by johngreer

Have you tried using different ports on the router? I had a similar problem and two ports were busted.

by deadly ernest

Unless you are accessing through a faulty port on the switch the most likely cause is the switch pc handshaking. This is best resolved by 'hard setting' the connection.

In the setting below I am assuming that you whole network is 100 Mbps full duplex capable. If not adjust comments accordingly. I am also assuming that you have checked the switch ports are OK and that the connecting cable is OK.

The most likely place to resolve this is the Laptop network settings.

First is the switch 10/100 Mpbs and how is it set.
Some switches are 'autosense' and autosense only, others have a little switch on the side that goes 10 100 10/100, if of the switch type set to 100.
(I bet the most likely cause is the NIC and the switch are not synchronising on speed, may be set to different speeds).

Open the Network Interface Card configuration settings and set it to '100 full-duplex', default setting is often 'autosense' and many systems have trouble connecting with the autosense.

NB: If hardware already hard set, try setting to autosense. Hardset is best but some hardware gets uppity about it and autosense allows continued connectivity if one item going flaky and dropping speed.

Open the Network Connection settings and check that the IP address and host name do NOT conflict with any of the other computers. Check that the sub-net mask EXACTLY matches the settings on the others. Check that the Workgroup name EXACTLY matches the others.

TIP - I ALWAYS type the Workgroup name in with teh capslock on so that the name is stored as capital letters. Some systems can accept this data as only upper case and will automatically convert it, others can store as mixed case. By ensuring that it is ALWAYS uppercase you eliminate the likelihood of any errors here.

Then check that the information for the gateway is entered correctly.

This discussion is closed to new replies.