Discussion Locked

added NT Seed router, Macs drop off net

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had to make my PDC a seed router
because Adobe asked me to make a
zone to get their print drivers working with
out corrupting.

I made the zone and all Mac computers
and printers connected to the zone. Now
all the mac's seem to be dropping and
reconnecting to the network. They are
running OS9 so they get a pop-up
message saying the appletalk connection
gets disrupted.

5 replies

by mikel~t

I would recommend using a BDC as the seed router to take a little strain off of the PDC, but I can't remember if this is allowed or not...it's already been a long week. Anyway, if you are running a 100 base-T network, or even a 10 base-T network, you shouldn't be seeing this problem unless there is a network card failure on the PDC. You might want to download etherpeek and check to see if there are any fluctuations or broadcast storms on your network. I would also recommend investing in repeater/hubs instead of just unmanaged hubs on your network. You didn't mention the number of macs in your zone, but I have hundreds on mine, and I only see Appletalk network errors when there are broadcast storms due to a back machine out there.

Good luck.

Mike

by acattr

Thanks for the suggestions, but it was a appletalk setting in the PDC. I put everyone on the same appletalk network by setting network numbers 1 to 1.

by espen

I've had this issue when having two zones
on two PDC's in two NT domains.
It somehow seemed to dissappear when
I joined the two NT boxes on the same
Appletalk Zone.
I suspect the problem was caused by
overlapping appletalk addresses, or
something in that ballpark. I had to go into
the appletalk control panel to update the
appletalk address before being able to
re-connect again.

It caused a entry in the NT event log, so I
suspect you may be able to trace the
issue back.

Espen

This discussion is closed to new replies.