Discussion Locked

Apple Laserwriters

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Whenenver I send print jobs to my laserwriter 800 this is the response: "a problem with the printer, ensure the printer is connected to the port you want to use and that it is on" I have a Quadra 610. The printer monitor on the screen shows that it is not accesible (X). How can I solve this problem?

13 replies

by john.kinard

Assuming that you still have a good network connection between the two, you might try re-selecting the printer in the Chooser and allowing it to add a new printer icon on the desktop. I've seen this same X'ed icon on the desktop whenever I've bootedwith a secondary hard drive. Using the Chooser to select a "new" printer creates a new functional printer icon on the desktop. Of course, if you can't see the printer at all in the Chooser, then you've got a network or hardware problem to diagnose.

by dj4277

if the first answer does not work, try turning background printing either off or on, based on it's current setting. if you have installed new software, it could interfere with printing. good luck

by benobi1

OK assuming that this is a local printer and that it is in a ready state at the printer side, and you turn on the printer first then the computer, and all else has failed then you may want to reset the pram and that will usally free up the ports on your computer, but then you would need to reinstall the printer and reset alot of settings like prefrences. but this is only if all else fails.
good luck

by gareth.hardman

Since you are using Desktop Printing (hence the x icon), drag the icon to the wastebasket. Next, go back to chooser, select the printer in the list (if it is there !, if it isn't then that is where your problem starts) and create a new printer usingauto configure.

by michael_ehs_it

Your Mac & LaserWriter connected to each other by AppleTalk.
1. ReINSTALL your printer driver & software CD, then restart your Mac.
2. From CHOOSER, you active by select LaserWriter8 icon in the left block,and select your printer at the right block, then hit SETUP to create a printer icon on your desktop with a link. Make sure your AppleTalk is active.
3. Change your Page Setup with your correct printer name on the upper left.
4. Create a simple text file and print it. double check your printer name at lower right on print windows with PRINTER button.
Hopefull, you make it work. If not, you have to initialize your hard drive install fresh with all apps + printer software.
PS. You did not tell what OS you installed on your Mac, What application did you install or run before this problem came up. Please mail me, I my know your problem. OS 8.6 is OK, but older than that it could be. Good Luck. MN

by espen

Chances are the queue has been
stopped.

Go into the desktop printer, go to the print
menu, and select start queue.

Espen

This discussion is closed to new replies.