9 replies
by kameronroxursox5 Accepted solution
by thumbsup2 Accepted solution
by oh smeg Accepted solution
If it has not worked it is most likely a Chip Set incompatibility between the Video Card and M'Board Chip Sets.
When this happens the fans keep running but you get no response for the M'Board or Monitor.
Or if this has been working previously what has happened recently? I do agree to test this monitor on another computer or use another monitor with this computer but it is also possible that the PS has lost one or more of it's critical Circuits.
So there are effectively 3 possibilities here the Monitor has died and gone to Silicon Heaven, The Video Card has carked it and gone to Silicon Heaven or the Power Supply has failed in some form and gone to Silicon Heaven.
Does the Monitor get any display at all?
If you disconnect the monitor from the Video Card do you get a message that it is not connected?
I saw one case where a PS had died but the fans ran the only real give away was that the Monitor showed a Disconnected Signal when you turned the power to the Case on. When you turned it off the monitor behaved normally.
In that case the owner bought new M'Board, Video Card, CPU, RAM and Video Capture Card. They bought these one at a time and replaced as they bought them then brought it in complaining that neither the old or new parts worked. When I changed the Power Supply both the old & new parts worked. But they did save themselves the cost of me fitting the new parts except for the Power Supply. :D
Col
by kameronroxursox5 Accepted solution
by thumbsup2 Accepted solution
The type of beep you're receiving is an indication of the problem. So, tell us if it's a short beep or a long beep?
Also, are you absolutely sure you've plugged the card into the right slot and it's snapped down into place?
by kameronroxursox5 Accepted solution
by oh smeg Accepted solution
I think you'll find that it works after you plug one in and most likely both Video Cards will work as well.
Col
by kameronroxursox5 Accepted solution
by oh smeg Accepted solution
Here is a link to the BIOS Beep Codes. These are a error message telling you what is wrong here. If the other PS worked what made this one different?
And since You Know that the Other Power Supply works have you thought to test it in another computer?
This discussion is closed to new replies.
Trending Storage posts
Sort by Trending