Discussion Locked

Power problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm not sure if this is the place for this question but hopefully someone can help. I have this Mac performa 6400 version 7.5.3 and I wanted to install a cable modem so I first installed an ethernet card. Then it turned out the cable modem was only compatible with versions 8.0 and higher on the mac. So I took out the ethernet card so I can return it. Now when I try to turn on the system I get no power. I checked to make sure nothing was loose, but I'm not sure what else to do. Please help.

5 replies

by aclark

Some Performa models will not turn on if the CMOS battery is dead or weak. This may be the case if you disconnected the power cord from the Mac while installing and removing the ethernet card. Some Macintosh motherboards have a microswitch to reset the system, press and hold for 10 seconds if it's on your motherboard. Also make sure to reseat the RAM and Cache card.

by nicholas paras

Try installing the card again, and then if it powers up remove the driver files of the ethernet card and then power down. Remove the ethernet physically from the mac and try to power up.

hope this helps.

Nicholas.

This discussion is closed to new replies.