Question Locked

Setting up a wifi bridge with switch correctly

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have recently purchased a Unifi Building bridge, a mini flex switch, and a Cloud Gateway Ultra to get internet from my house to my farm shop. These devices were recommended by an IT friend. He is out of town and I am ready to install everything but no very little of the correct hookup procedures. I apologize I am unable to put pictures with my question. From the bridge on the shop, does the cat6 wire go to the mini flex? If so, which port does it go to? Then I assume the cable that came with the Ultra plugs into the miniflex as well? Again, if so, which port? I also have a cat6 wire coming from my overhead door that I don't know which device it plugs into (flex or Ultra). This is needed because the manufacturer offers a door opening app. Does it also plug into the miniflex or into the Ultra? All of this is very foreign to me so any help is appreciated.

5 replies

by rproffitt edited

Even if you plugged it in correctly you would go down in flames over the software install and configuration.

Call Unifi support and see how much it is for install support. As this is your first time, figure a day to get it all going.

by kees_b

Or maybe better: wait till your friend is back in town.

by Jacky

Yes, the cable from the shop bridge should go into the Flex switch first. Then plug the Cloud Gateway Ultra into the Flex as well. Your overhead door Cat6 cable will also likely plug into the Flex. The Flex basically acts as the connection hub for everything in the shop.

by kateparker7788 edited

Hey! Solid gear choice. Since the Cloud Gateway Ultra stays at the house as your main router, here is how to wire the shop side:

Building Bridge: Plug the Cat6 from the shop’s bridge unit into Port 1 of the Flex Mini switch.

Overhead Door: Plug that Cat6 into any other port on the Flex Mini.

The switch basically acts like a power strip for your internet it shares the bridge connection with the door and any other devices you plug in there.

One quick thing: is the bridge unit at the shop already getting power from a little black PoE injector box?

by birdmantd

You really should hire someone to install it for you if there is that much doubt in your mind. It's difficult to offer any other advice to minimize any potential issues and ensure proper connectivity. Based on your comments, there is just too much that can go wrong doing it yourself.

I do wish you the best. Please update the community on your progress.

This discussion is closed to new replies.