Discussion Locked

1 Cisco router & 2 internet connections

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi. I have 1 Cisco 1605 router with 2 ethernet ports and 1 T1 port. I also have 2 internet connections that i would like to use with this single router; a 256 fractional T1 and a cable modem connection, both from different ISP's and each assigned a static IP address. Can I do some sort of multilink configuration were I can combine the bandwith of both connections ? Or can I select which type of traffic goes out which internet interface ? I any of this possible ? Also note; i have a sonicwall pro firewall behind the router to protect my lan and a dns server to sit in a dmz.

Thank you
rbowe@familyguardian.com

5 replies

by ckilday

You're not going to be able to multilink the ports. Once you connect both links to the Internet, both ISP's will be advertising different routes to your single network. This is not good. We ran into problems with BGP just trying to establish an Internet connection from two physical sites with the same ISP. However, we were able to segregate our traffic and now all of our Internet e-mail goes out one connection and our regular Internet traffic goes out the other. If that won't work for you, my next suggestion is to make one link a hot standby for the other using HSRP. Hope this helps. Best wishes,
- ck

by mckaytech

"Multi-link" or making both circuits appear as a single pipe with the combined capacity of the two is not feasible. And HSRP is for failover between routers, not between circuits, so it doesn't apply in this case.

However, the 1605 will support the FT1 through the WAN port, the cable modem via one Ethernet port and your network through the other. You do have some options as far as traffic balancing between the two links. You could segregate traffic by type, by origin (your workstation gets the cable modem - everything else goes out the FT1 :-) or something like that) or by destination. You could also prioritize traffic by using policy-based routing (as long as your 1605 is running at least IOS v11) and you can also configure automatic failover if a circuit should go down.

An excellent resource is Cisco's Web site. Search terms of 'DDR' or 'policy-based routing' will give you some ideas of the many ways traffic can be segregated and routed.

paul

This discussion is closed to new replies.