Discussion Locked

3 Remote Sites need connecting......

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Currently I have 3 remote sites that need to be connected to our main site. We are looking at using 56k Frame Relay lines to connect them. I am wondering if anyone has suggestions on what equipment to use and suggestions for configuration. I would like to find a way to have one router at the main site that can handle the 3 connections coming in. I was thinking of sticking with Cisco but any suggestions would be much appreciated.

Thank you in advance for your help.
Joe Blaylock

7 replies

by mckaytech

If you use Frame Relay, there will generally be only one physical connection at the main site with each logical connection to the remote sites existing as a "DLCI" that rides on that one connection into the frame relay "cloud".

For each site, youwill need a router and a CSU/DSU. With later model Cisco equipment like the 2610, you can get a CSU module (called a WIC) that plugs into the router so you just have one piece of equipment. Older routers (e.g. 2501) need an external CSU/DSU and a v.35 cable to attach it.

For assistance in configuration, you can download a program from Cisco's Website called ConfigMaker. Alternately, once you know what your equipment will be, you can write to me off the forum and I can send you an annotated sample configuration.

One thing you might consider is to get pricing on fractional T-1 rather than 56k (especially for the connection at the main office). If you decide to upgrade from 56k, you have to replace the CSU/DSU at each site, but if you go with FT1, you can start out with 128k and scale all the way to full T-1 without buying new equipment. In some cases, the small difference in cost makes a very compelling case for going with FT1.

paul

by jschultz

The configuration suggested by the previous person is exactly what we use. I would also agree that you would be much better off to connect via Frac T-1 with one channel. Otherwise, you need a DSU 5600. Actually, if you decide to go with a 56K connection, we have two used DSU 5600's that we could sell you. But, having upgraded two locations from 56K to Frac T-1 access in the past year or so, you are looking at up to 6 months for an upgrade to complete and then you have to buy new equipment on top of that. You can definitely have one router handle 3 connections and I recommend the internal CSU/DSU choice because we found it was cheaper. We bought a Cisco 3600 router, but that may be overkill for you. I would also recommend getting specific recommendations from the business providing your frame. Often, they have network engineers where you can get free assistance. OH, and, if you decide to buy a router, call AT&T or Ameritech or another provider that purchases a lot of equipment from CISCO. They get great pricing! Good Luck!

by borg7of9

I am using fractional T1 frame relay, but I am looking at using a DSL connection and running a VPN over the internet. Depending on what application you are running across it this may be a more economical solution. Your local ISP's can usually help you set this up.

This discussion is closed to new replies.