I’ll pay 3000 points for this.
I’m new to Cisco and need to set up a router between the inside of my firewall and the network. Why is long and drawn out, but there’s a reason.
Here’s how I need it set. I want my computers to use this router as agateway. The inside port (e0) of the router has an IP address of 10.2.1.1/13. This is the gateway I want to point my computers at. The outside port of the router (e1) has an address of 10.1.1.1/13. The next port is the inside of the firewall, 10.2.1.20/13. The outside port of the firewall is a public address, then on to another router and the T1. If I can just get all out bound traffic to hit the inside port of the firewall, it should take care of it from there.
So here’s the question. I’ve set the ip addresses on each of the ports, so what else do I need to do and how? Let me know if you need any mor info and I’ll gladly provide it.
It’s probably something simple, but I’ve never done it before and will pay 3000 points for an answer.