Anybody know how to do Portforwarding on Watchguard
I have a Firebox X750e and I dont know anything about this boxes. I need to do port forwarding on it to be able to use VNC.
Can anybody please assist.
Thank you
Oz
Networks
I have a Firebox X750e and I dont know anything about this boxes. I need to do port forwarding on it to be able to use VNC.
Can anybody please assist.
Thank you
Oz
by oz_cast Accepted solution
by netman1958 Accepted solution
by oz_cast Accepted solution
by netman1958 Accepted solution
my suggestion here:
https://www.techrepublic.com.com/5208-6230-0.html?forumID=101&threadID=273692&messageID=2596529
by jdclyde Accepted solution
I have a 550, but setup wise, it is the same.
When I get into work in the morning, I will take a look.
Posting this now, so I will be able to fine this then..... B-)
The longer I have the watchguard, the more I miss my SonicWall. :(
by oz_cast Accepted solution
Jdclyde:
I hate the watchguard box, but I came into this company and they already had it. I know more about Cisco than this box.
hope you can assist. Thank you
by jdclyde Accepted solution
but don't remember exactly how right now.
this is the single worst piece of crap firewall I have ever seen, and the FIRST graphical firewall that you can't just sit down and use.
The support sucksass as well as their site, too. X-(
I will try to look at it closer this afternoon. Sorry nothing good to report yet.
by jdclyde Accepted solution
by oz_cast Accepted solution
I was playing around with watchguard and finally figured out how to do portforwarding.
Not sure if it works the same way on all watchguards but this is for a Frebox x750e
1:log into watchguard
2:open Policy Manager
3: select the + sign or edit add policy
4: Under Add Policy select New
5: Name your New Policy Template my case VNC
6: whatever you want under description.
7: Under Protocols select Add
8: Type: my case again "Single Port"
9: Under Protocol: TCP
10: Server Port: my case 5500
11: select OK. then OK again. thats just to create a template of the port you want to forward. Then you have to do the following.
12:under Add Policies you are going to see a folder name Custom. You should see the template you created. My case VNC.
13:Select the policy and click on add way at the bottom of that box.
14:the Tab Policy : From remove any-Trusted and Add: ANY.
15: To: select Add should use Add NAT make sure you know what your external IP address is.
16 Internal IP: the computer you want to use to forward your port.
17: Port 5500 click on to all and save.
thats all I had to do.. kinda of blindly but it worked for my 10th tried.
Regards,
Oz
by jasunto Accepted solution
This discussion is closed to new replies.
Sort by Trending