Discussion Locked

ASCII, DOS, and printer ports

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
While working with a DOS program, LC50, it appears that I am unable to print its files to an HP Officejet 7210 printer. Same thing happens when I try to print ASCII files. Both the ASCII and DOS files end up getting sent to an LPT1 port to a printer that isn't connected to the computer, but still shows up (Intuit Internal Printer). Any thoughts would be greatly appreciated.

2 replies

by charliespencer

Is the printer connected to a USB port? If so, there may not be a way to print to it from these older applications. They may be hard-coded to go to LPT1; many DOS apps were. Hopefully all you need is a parallel printer cable, assuming your printer has a port for one. Then go to Printer Properties for your 7210 and change the port to LPT1. You may have to get a parallel printer.

Do you have any Intuit applications currently installed? If not, you can delete the Intuit Internal Printer.

by tonythetiger

Your officejet is on a usb port.

One way is to "share" the printer on the network, then redirect LPT1 to print to the share.

Another way is to install a printer on LPT1 (even though you don't have one), and enable printer pooling.

This discussion is closed to new replies.