Discussion Locked

Boot Disk

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am attempting to create some dos boot disks that will connect to our Netware 5.1 servers via IP, Does anyone know where I could get one or how to make one. I have attempted using novell's tid's that doesn't work...We are running in a pure IP environment. I have most of the disk working other than getting dos to recognize my NIC...??? I know there is nothing wrong with the nic or my system... and I know I am using the correct driver so I am guessing there is something that I am not loading ????

9 replies

by stngfan1

Try bootdisk.com they have many. Did the NICs have dos drivers with them. Some of the newer ones only connect with Windows.

TM

by jimbb

Good old DOS? Then maybe you're having a good old NET.CFG file? In there you should have a section for your NIC (like "3C509" for an Etherlink III for example), and some cards require you to put the right configuration parameters. Unfortunately there are no "standard" keywords: INT and IRQ can both refer to the same, depending on the manufacturer.
Recent cards and drivers however can figure things out themselves. Some examples given with the drivers may even contain incorrect parameters for your card, or for the way it is configured. Try omitting any INT, MEM or so, or try filling in the correct ones.

Still presuming you'r using an "old" DOS client, the things to load depend on each other, and as soon as you try to load something before a requirement is there, it will tell you. If I don't remember wrong, it should be:
1. LSL
2. IPXODI or IPODI
3. card-driver (like 3C509 or N100 or so)
4. VLM

If you let Novell's DOS client install handle things, it should create a STARTNET.BAT that does these things.

Jim

by newkirkd

I am attempting to create an IP boot disk. Not an IPX, the problem that occurs is that I don't know what I need to have on the boot disk to load the IP protocol, everything that i have attempted so far requires at least 2 disks..... The NIC drivers are not the issue, it is loading the IP protocol stack and how to do that??? Thanks, for the response though

by lelton

Start with a 3com 3c905b card,

Does the .com driver load if you are just configuring lets say for ipx ? If not then you have a lan card driver problem.

I would then test with a 3c905b card using the standard .com driver. That driver WILL load, then after you have made one working bootdisk, branch out to other nic/driver combinations by edditing the net.cfg and the startnet.bat in the a:\nwclient directory of the boot disk. If you need help with the configurations just replay back and Ican give you lots of cut and pastes.

Dos works, ra ra ra
Windows might, bla bla bla

Les

by newkirkd

I am attempting to create an IP boot disk. Not an IPX, the problem that occurs is that I don't know what I need to have on the boot disk to load the IP protocol, everything that i have attempted so far requires at least 2 disks..... The NIC drivers are not the issue, it is loading the IP protocol stack and how to do that??? Thanks, for the response though

This discussion is closed to new replies.