i have a dell power edge 1400 server unit.the mother board has two processor sockets.up to 1.5 ghz.i have one 733mhz proc’ installed with a voltage regulator module installed .i have a second processor but no vrm.ihave some old m’boards i picked up with a vrm slot on them,although they have no vrm,but have jumpers in place instead.some four or so on around16 pins.is it possible to remove my existing vrm and place jumpers across certain pins[at my own risk] even if it means a slight reduction inperformance.the reason being for this is that i have had great difficulty in obtaining a second vrm.system spec’s at moment are 733mhz proc’ 133bus,256 cache 512mb ecc 133 sd ram,quantam atlas scsi hard drive[9gb]uniprocessor support?do i need added system requirement from microsoft.i am running win xp pro