13 replies
by george.kyriacou100 Accepted solution
by deepsand Accepted solution
I've seen cases where a client has leased/purchased a PIX from an ASP, the PIX now needs to be re-configured, finds out that the ASP has been subsumed by a different company, only the original ASP had record of the Access Code, so that their PIX is now little more than a doorstop.
Hence the question as to how you came to have this device.
by george.kyriacou100 Accepted solution
by deepsand Accepted solution
Unfortunately, unless you can get the old IT company to produce the access code, you're sunk re. reconfiguring it, unless you can find someone whose has expertise in cracking Cisco PIXs; that's why the new company replaced it with a new unit.
However, you may still be able to use it. If it was originally used as a gateway, odds are that the internal IP address assigned to it is within a fairly narrow range of commonly used addresses.
The 3 blocks reserved for private, i.e. local networks are
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
Also, IP addresses in the range of 169.254.0.0 -169.254.255.255 are reserved for Automatic Private IP Addressing.
If you know, or can find out, the range of IP addresses used by the LAN from which this PIX was used, we can deduce the most likely address(es) assigned to it.
by george.kyriacou100 Accepted solution
by oharaphil Accepted solution
if you follow: http://www.cisco.com/warp/public/110/34.shtml
See if it helps
by george.kyriacou100 Accepted solution
by cruzramirezjr Accepted solution
Hey you guys, I stumbled across these posts while researching how to recover/remove unknown passwords from a Cisco PIX 501 that I have. The documentation posted at http://www.cisco.com/warp/public/110/34.shtml worked like a charm.
I followed the instructions step by step, I connected the PIX to a LAN switch via Ethernet0, assigned it a local LAN address, downloaded solarwinds tftp server as well as the corresponding .bin file for my PIX sotware version. I ran the tftp server on the laptop I was using to console to the PIX, specified my laptops LAN IP as the tftp server, everything work without a hitch, I was able to remove all the passwords.
Thanks a lot for the info!
by deepsand Accepted solution
since the most commonly used IP range for LANs is the 192.168 block, and the most common practice is to assign the gateway the 1st address in the last octet, so that most have an address of 192.168.1.1, or 192.168.2.1, or 192.168.3.1, etc., you might easily find it via a brute force approach
Additionally, if it might be of help to you, I do have a complete image of Cisco's 2 CD set for the PIX series.
by deepsand Accepted solution
If so, your marking it here accordingly will be of use to others who seek the same or similar assistance.
Thank you.
by jl.roduit Accepted solution
I have the same problem mentioned and i don't know how to replace the old settings by the old one's.
This morning i tried to change the IP address of the pix and now impossible to reach the address I configured.
Any solutations ? thx in advance
by pcoleman Accepted solution
by mr.ozzy Accepted solution
connect your pc to router's lan port
and select your pc's ip to obtain ip address
and check your pc ip address
e.g..192.168.0.1
so..ping to 192.168.0.2 to 192.168.0.254
if there router's ip ,reply and you can get your router ip address.
just guess my opinion.
thanks
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending