15 replies
by mckaytech
If you're asking if a remote user can have a VPN tunnel up and browse the Internet at the same time without going through the tunnel for that browsing, not without a special setup on the workstation.
It is theoretically possible on NT4 Workstation or W2K Professional to use a routing statement to direct corporate traffic to the VPN and browsing outside the tunnel, but I don't know of anyone who has been able to get it to work right.
paul
by dp
by bobhood
When you set up the VPN connectoid under dial-up Networking, on the third tab, uncheck "Use default gateway on remote network".
This will fix the problem!
Finally, take a look at
http://cable-dsl.home.att.net/#VPN
for more than you wanted to know about VPN. See the first subject after TOC for your particular problem.
by dp
by kwacha
Yes you can, but it involves a trick. You will also be opening a security hole so be sure that the client machine has a good firewall installed.
When your vpn connection is set up a new default gateway entry is made into the client route table.The previous (ISP) gateway entry is still present but with metric 2 which means that Internet requests are going to go down the vpn pipe.
Delete both entries from the route table. Add the old entry back with metric 1. Add another entry to routeyour corp network traffic down the vpn pipe.
Voila...access to your corp servers will use the vpn pipe, access to other Internet addresses will use the ISP gateway.
This can be done manually or, as I did, you can setup a simple automated process to do it.
You can learn to use the ROUTE command by using ROUTE /?.
by dp
by eronay
by dp
by eronay
by dp
by dp
by dp
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending