Discussion Locked

Can't get into a Cisco 2924XL

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

TechRepublicans,

I've got a Cisco 2924XL (IOS 12.0) that I was trying to do the initial setup on, but instead of being prompted to specify the IP info, I get a switch> prompt.

Moreover, I can't get into the exec to do a show run or change any info. This was a new router, so I don't know why it did not run the initial setup routine. I ran it on two other switches without a problem.

Is there a default password that these things come with that I can use to get past this, or is there a wayto return to factory config?

If anyone has any ideas, it would be greatly appreciated.

Regards,

Joe

5 replies

by zen37

Generally, Cisco devices default password is "cisco".

If that does not work, you may need to do a password recovery.

good luck

by mckaytech

You'll need to do a password recovery most likely. If you have a CCO login, you can go to Cisco's site, do a search on "password recovery" and you'll come to a page with the procedure for your product (29XX switches).

They have the whole procedure, step by step. It's not trivial but as long as you have physical access to the switch and a 9600 baud console connection, it usually goes pretty smoothly.

I've had this happen a few times when a "new" switch apparently visited somewhere else in the distribution chain before it arrived on my doorstep.

paul

This discussion is closed to new replies.