Discussion Locked

Capacity of a CISCO Cat5000 Switch

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi everyone
Due to staff changes at my workplace I suddenly find myself in charge of a vast array of network critical CISCO switches (reading and training are a constant part of my life now!)

One question I have for some more knowledgeable CISCOpeople out there. What factors do you need to take into account when looking at the capacity that a Cat 5000 switch can serve? From what I have determined, the actually number of ports that the Cat5000 can service is 528 (depending upon configuration of course), but what about required bandwidth to service x number of ports. If you were to increase the number of ports serviced by your Cat5000 from 200 to 300 (for example) and you have 155 Mb/s ATM fibre running into your switch, will that result in a significant performance hit for those PCs?

Any assistance in this matter is greatly appreciated

Dary Sheppard
daryl_s@bigpond.com

5 replies

by road-dog

Check stats on the uplink port, look for discards. If this is OK, it might take it. Traffic analysis is tough without knowledge of topology, like are the servers on the switch or is all server traffic moving across the uplink?

The limiting factoris the uplink, not the switch.

by mcoya

To answer this question you have to ask yourself what you want to accomplish with this switch? Do you want redundency do you want routing cabilities or do you just want bandwith. The beuty behind the catalyst 5000 is that it's modular and you can do anything you want to expand and improve upon it. To answer you question on a more technical level. The 5000 has a 3.6 GPS backplane it supports switch clustering, and has 13 modular bays. It supporst 396 100baseT ports and 528 10baseT ports. That should do in most applications. Email me if you have any other questions

This discussion is closed to new replies.