4 replies
by evkuo
I'd check with your ISP, but usually you can do it one of two ways:
1. Setting your S0 interface to unnumbered and then giving the public IP to E0 (see http://www.cisco.com/warp/public/701/20.html). Then, since they're on the same subnet, you don't have to do much routing on the interfaces.
2. On PTP lines, set the S0 interface on the routers on both sides to a highly restricted subnet (let's say 192.168.4.1/31 so one side will have 192.168.4.1 and the other 192.168.4.2). Then you'll need to set the routes accordingly.
Either way, I'd have the firewall do the NAT'ing and remove all ip nat and nat pool statements on the 1700. It might be cleaner to just re-do the 1700, but I'd backup the config via TFTP (or just cut and paste it to a text file) before I did that.
by rcs29us
the ip ths service provider gave me are:
for example:
64.113.128.245/30(255.255.255.252)
64.113.128.246/30(255.255.255.252)
64.125.198.64/27(255.255.255.224)
how do i assing that to the router to be able to connect to the internet????
thanks
by kpese2000
Use the ip address command on the either the serial interface or ethernet int to assign ip addresses e,j:
config t
int s0 0r e0
ip address 64.11.128.245 255.255.255.0
no shut
exit
You still need to come out with more details as to what you are asking.
by chrisnett
I have a 1750 with IOS c1700-k2o3sy-mz.121-22c.bin with a ADSL WIC
I have 5 static ips assigned by my ISP sbc.
They provided me with a natopia 3346n ADSL gateway. I'm confused on two things.
1. The gateway has one RJ 11 that is comming through the wall jack, and it has 4 ports for cat5. How do I plug it into the 1750?
2. How do I config the router to communicate with the gateway?
I've only completed CCNA 1-3 at the acadamey.
please help.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending