Question Locked

Cisco 1720 router connecting into a home network

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Cisco 1720 router, with a WIC-1ENET card installed in the WIC0 position.

I would like to install it between my cable modem and Linksys WRT54GL (broadband router).

I did buy the Cisco router unpopulated, and then bought and fitted the WIC-1ENET card. I think I read somewhere that the IOS on the router had to be a certain revision in order for the Ethernet card to work. Is this true and if so can anyone let me know what revision it should be and how to get hold of it?

The IOS version on the router is 12.3 (10b).

Also do I have enough with the routers 10/100 Ethernet RJ45 connector and the 10BT Ethernet on the WIC-1ENET card to do what I want?

I am a beginner with Cisco and would really appreciate any help, can anyone let me know how to configure the router IOS to protect my network or where to find the information necessary?

Regards
Chris Barker

3 replies

by eric

Hi Chris.

First, let me say that I'm not a a Cisco expert, but I know a little about this because I'm playing with a couple of 1720's myself in an attempt to learn more.

My 1720's had ( I think ) 12.1 (3) on them and would NOT see the WIC-1ENET in WIC0. I don't know if yours will or not with 12.3 (10b ) but I do know that 12.3 (26) will work.

Checking to see if your WIC-1ENTs work should be pretty simple. Mine gave an error message on the serial console while they were booting, and when I did a "show ip interface brief" the the WIC-1ENET card didn't show up in the list, just FastEthernet0. With updated firmware you should also see Ethernet0 in the list.

Finally, if you're going to use the 1720 as the router in your network, you will probably want to disable the router features of the WRT-54GL and use it just as a wireless access point and switch.

Have you considered some of the alternative firmware options for the linksys, like DD-WRT or Tomato? They offer some pretty interesting new capabilites to your linksys.

Eric

by ic-it

You will likely need to refresh the cable router (to release the MAC it first tied to) in order to establish a full connection. Here is a nice link that will give you an idea of using the IOS to secure your router/LAN;

http://www.dslreports.com/faq/8020

This discussion is closed to new replies.