Discussion Locked

Cisco 2611 won't boot

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I did something stupid. I put in a new value for confreg (I can't remember what it was) and now when the router boots, I see stuff that looks like this: ?H?H???

Anyone know how to get my router up and running again?

TIA

Dan

5 replies

by dashaba

i think u accidentally inputed a wrong value into the config-register;use ROMMON to get into it, then change the confreg to its original value

by dsalazar

I found out through a newsgroup that I did change the config-register, but even ROMMON wouldn't fix it. I had changed the default console port speed. I stepped through all the possible speeds for my serial port and finally found the correct one.

by dashaba

i think u accidentally inputed a wrong value into the config-register;use ROMMON to get into it, then change the confreg to its original value

This discussion is closed to new replies.