Discussion Locked

Cisco and networking

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am Daljit Singh Arneja
I am looking for some sort of simulator of CISCO router
Where can i find it.

1.In how many ways can QOS be configured on cisco router?
2.Can you provide me software of checkpoint firewallor its demo?
3.what is cost of cisco 1600 & 1700 series router?
4.I have got 2 ISP connections,,, my Boss want that i should configure
cisco router in a way that the traffic goes out from one router to one ISP
and traffic comes into the network from other router from other ISP?
I have 2 CISCO Routers)
5.If i am given option of using Cisco router or Layer 3 Switch,,,which should
i prefer and why?

6.What is SNMP,,,how can you configure SNMP on cisco router
or what r its different ways of configuration.?
7.Whats is IPSEC,what r various encryption method
how can you configure them on cisco router?
8.suppose some one erased the flash,,,and rebooted the router
what will happen,,,imean will router run its startup config?
9.Same case as abovethat i have taken backup of Flash on tftp server
how will i reload the flah back into router flash memory
kindly take both the case above and reply to these question in detail

10.what is RSL(is it router software loader)
is yes then where can i get this software...?

5 replies

by fgarber

Don't know about Cisco simulater. As to the rest of your question -
1. An infinate number of possibilities. The manual shows the most often needed configurations.
2. http://www.checkpoint.com/getsecure.html for evaluation copy.
3. Around 600 - 700 depending where you go. Check out www.insight.com.
4. Check out TechProGuild at this site and go to tech books. Everything you need is there
5. I prefer Cisco router. Ease of configuration.
6. Simple Network Management Protocol. Configure according to the manual that came with the router.
7.
8. Not sure.
9. Includes 10. RSL comes on the CD that comes with the router. Cisco tftp also comes on the cd. Complete instructions for the use of both are at www.cisco.com in the support area.

by mckaytech

In regards to question 4, you would configure access-lists and apply them to each interface as appropriate. With an access list, you can define the source, destination, protocol, port, etc. so one access-list would only permit outbound traffic to the one ISP and the other access-list would only permit inbound traffic from the other ISP.

#7 IPSec is short for IP Security. It's a protocol for securing traffic en route across the Internet but how you apply it depends on what you're doing (VPN, remote shell, etc.)

#8 Yes
#9 You'll tell the router to boot from the TFTP server and then save the configuration. The exact syntax depends somewhat on the version of IOS you're running.

paul

This discussion is closed to new replies.