Discussion Locked

Configuring a ProCurve 2524 Switch

0 helpful

5 replies

by tbwolfe Oct 6, 2003 last reply Oct 13, 2003

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Can anyone tell me the commands needed to configure the proper time/date on a HP ProCurve 2524 switch.

5 replies

When you are at the CLI (Command Line):

Enter Configure (This will put you in the config mode)

Clock Set HH:MM:SS for time
Clock Set MM/DD/YYYY for date
Timezone (enter in timezone differential i.e. +6 for central time)

hope that helps.

Poster rated this answer.

If you go out to HP's site or search for it on google you will find a full list.

Poster rated this answer.

This question was closed by the author

This discussion is closed to new replies.