Discussion Locked

Configuring CISCO router for NAT trans..

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to configure a cisco 1604 router to accept PCAnywhere requests on a single public IP and route it into a private internal address.

I believe I am doing it properly, but I can't get it to work.

Does anyone have a known configuration?
I have 157.234.240.234 and need to get to 192.1.1.119.

Thanks for all help!

5 replies

by cviescas

Thanks, but been there. Although it appears to all be valid, PCanywhere, FTP, E-mail nor Telnet will passthru the router.

by mckaytech

I don't have a specific configuration that is any different than the sample configurations at the Cisco link already mentioned.

What you're trying to do has two separate parts - the network address/port translation and the access-list part. I would make a wild guess that your problem is with the access list part.

What I usually do when setting up a NAT router is get the NAT part working first and then apply the access lists. Where I tend to run into problems with access lists is in forgetting that there is an implied "deny all" at the bottom of every access list. So if you have any access list at all, you have to explicitly permit the packets you want.

paul

This discussion is closed to new replies.