Discussion Locked

Configuring PPP on Cisco routers (2900)

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Im trying to establish a connection between to cisco routers via a serial interface using ppp encapsulation. I configured the ports and verified i had a correct IP address. My problem is I cant ping my own serial port, and I keep the serial port line & protocol keep changing from a down state to up state...???

5 replies

by leebs

Based on your information I suspect that you either have a bad card slot or it's not seated properly. Check your physical connection once again and make sure everything's on it's place and seated properly. If this doesn't resolve the problem, it'smost likely your configuration that's causing the problem. Send your question again with your configuration settings and I'll take a look at it.

by elionet

I found out its a configuration issue... because these new routers have VPN capability ... and its not compatible with the DCE im using ...

by ckilday

I don't believe you can ping an interface that's in a down state. Have you verified your modem configurations? Is the line between the two sites operational? Your problem sounds more like a problem between the router and the modem than with the modem itself. What results do you get when you do a show interface on the router? At the bottom of the display, you will see 5 signals,...DCD, DSR, DTR, RTS, CTS. They all need to be up for the circuit to be operational. DCD is data carrier detectand comes from the modem. DSR is data set ready and also comes from the modem. DTR is data terminal ready and is provided by the router interface. RTS is request to send and CTS is clear to send. They refer to the interface signalling it has data to send and the modem saying it's ok to send data. Check these out and see what you're getting.

If you have access to Cisco's web site, they have a troubleshooting guide with tips on what to do for specific situations. For example, if your DSRis down, they might suggest checking power on the modem. Stuff like that. If you don't have access, drop me a line with your results and I can take a look through my copy.

Best wishes,
- ck

by elionet

I found out its a configuration issue... because these new routers have VPN capability ... and its not compatible with the DCE im using ...

This discussion is closed to new replies.