Question Locked

Default Routing and Propagation of Default Routes On CISCO Routers

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, I am a newbie studying for the CCNA,

with a question about the propagating of default routes when routing is enabled(RIPv2 OSPF, EIGRP, etc)
I have designed a network with different default routes I want to use, depending on the router (if it matters, for the switch, the default gateway is the ip of internal firewall router; for the internal firewall router the default route is the super-ip address for the proxy servers, which are configured as routers with ip forwarding; for these proxies, the default route is the ip of the external router)

Thus, I want to statically configure all default routes,
and I don't want any of these routes propagating to the rest of the routers--I understand that the default gateway configured on a switch--which does not do routing--will not propagate??

Think the default route configured on a router is not propagated by ospf even with routing on

In fact, I think only ip default-network command propagates a default gateway--otherwise, if you want default routes propagated, you have to do some more configuring.

Please advise. Is this correct???

--CEW

1 reply

This discussion is closed to new replies.