The most important thing will be to configure DHCP relay on the layer 3 switches in the routing interface. You will need to add the
ip helper-address xxx.xxx.xxx.xxx
ip helper-address xxx.xxx.xxx.xxx
to each VLAN you create.
To recap the DHCP process
- machine sends a broadcast to request an IP address on the local ethernet segment.
- if the DHCP server is local it will reply with a unicast packet to the workstation with an IP address and the appropriate options.
- if a DHCP relay agent is configured the broadcast will be forwarded to the DHCP server. The Relay Agent adds to the packet where the request came from so that DHCP server can reply with the IP address.
On Cisco 6500 you need to configure the "ip helper-address" command to setup DHCP relay. Note however, that this command is a universal type of command that is used to forward broadcasts for a number of protocols. One of these is NetBIOS broadcasts and if this is done your Network Neighborhood (which uses Microsoft Browser which relies in turn on UDP broadcasts) make sure you disable forwarding for these protcols. Here is the commands to do this
no ip forward-protocol udp tftp
no ip forward-protocol udp nameserver
no ip forward-protocol udp domain
no ip forward-protocol udp time
no ip forward-protocol udp netbios-ns
no ip forward-protocol udp netbios-dgm
no ip forward-protocol udp tacacs
If you have two ip helpers you can have two DHCP servers. But both of them will show an allocated address, the machine will use whichever packet it got first.
Hope this helps.
Greg