Question Locked

DHCP server conficts with Linksys router

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello everyone,

I setup a wireless Linksys(wrt300n)router on our network with DHCP enabled, so employees who connect to it can access the internet.

After a short while, The main DHCP server on our Windows 2003 server shuts down as it detects a conflict.

HOw can I resolve this.
Many thanks

E. canaan.

10 replies

by dmambo

Is there a reason that you have a secondary router? Your primary router should be your gateway and an AP will give your wireless clients access to your network and therefore to your default gateway.

If the Linksys is your only router, configure it with a static (and reserved) IP address and use that as your gateway.

by e_canaan

DMambo,
Thank your very much for your reply.
I don't however understand exacly what you mean when you say use access point instead of a router.
I only have one router(linksys wrt300n - only to provide wireless connection) and this is how I have it setup:

- The "wan" connection in the back is linked directly to our ISP DSL modem.
- one of the other 4 available connections is linked to one of our network switches. So users can authenticate to the local network if needed.

So the router has one Internet(public) IP (i.e 142. etc...) and one Internal IP (i.e 192.168. etc...)

The default gateway on the router is set to the ISP's defaut gateway, as oppose to all clients internally whose gateway is set to the internal IP address of the firewall.
I hope this helps..
Thanks
E. Canaan

by sgt_shultz

then it will act like part of your network.
you need to set the gateway on everybody to your internal dns server and then put a forward on your dns server to send any address resolution queries for addresses outside the lan to your ips's dns servers.
how to configure the forwarders is found at support.microsoft.com
how to configure the router in bridgemode is found at www.linksys.com
having the isp field all your dns responses first is slowing down tons of stuff (including logons) on your network.

by rkuhn040172

Should be a simple check box.

On a small network (I'm assuming it's a small network since you're using a LinkSys router), you have a choice of using your server for DHCP or the router (not both).

My home network is setup in a similar fashion as what you describe. I use a D-Link though and have W2k3 server.

But with DNS and DHCP you have a choice, use the router or the server but not both.

If you wanted to get sophisticated about it, you could probably write a new DHCP scope and in it (I haven't tried this yet) you could specify to your client PC's the first DHCP server and it's fail over (the router).

by rkuhn040172

Anything else, let us know.

I, in particular, am pretty good at mixing and matching enterprise and home hardware/software together to come up with some pretty elaborate and cheap home networks.

by tae_song

I don't know if this will work, but you could try this.

You could assign one DHCP server 2-127 and the other to 128-254. (or whatever arrangement you use).

by e_canaan

Thank you sgt_shultz.. I will try that.
Regards,
E.Canaan

by arthurobot

your router is configured as dhcp server and at the same time using a windows 2003 server setup as dhcp server? two dhcp server must not run with the same network :-).if your router is configured to dhcp, i recommend static because if you are in dhcp the client computer will not know the gateway (internet connectivity) it changes every time there is a power outage.

This discussion is closed to new replies.