Discussion Locked

DHCP server's leasing

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am implementing DHCP in my Site. I will be having 2 nos. of DHCP servers in my Site. One DHCP server is working properly. Other DHCP server is malfunctioning. The problem is when I define a scope and give the lease period of 30 days, the lease expires in 20 minutes. This causes IP clashing. For eg. I have defined a scope 10.2.210.0. Range is from 10.2.210.101 to 10.2.210.200 with subnet mask 255.255.255.0. Lease period is 30 days. I have 10 PC's in this segment. All 10 PC's take the lease serially. But after 20 minutes when I see in the Active lease option, some of the IP addresses are dropped.
Can you help me to solve my problem.

Regards

5 replies

by Former member

Why do you have 2 dhcp servers again?

by jayesh_nishane

The solution to the problem is that Windows NT service pack 6.0 is to be loaded on after starting DHCP server services. If you start the DHCP server services after loading service pack 6.0 the same problem exists.

by shanghai sam

Load balancing for excessive network traffic and redundancy in case the PDC crashes are not great reasons for having multiple DHCP servers. High network traffic, in the case of DHCP leasing across a router, will cause relay agent request traffic. Redundancy might be a good argument, but a DHCP scope can be created on a BDC in minutes with the proper scope documentation. On a non-routed small business LAN, even if it’s subnetted, two DHCP servers are impractical and can cause the sort ofconflicts reported unless they are configured correctly.

Please check the list below and see if any apply to the issue:

?DHCP servers don’t exchange information with each other. Make sure that no two DHCP servers’ scopes overlap.

?The DHCP server only acts upon client reservations where the reserved address is part of the available address pool. To avoid conflict create the same reservation on other DHCP servers that exclude this address.

?DHCP servers must all use static IP addresses. Leave some of your assigned IP addresses outside the lease scope and make a reservation for your servers.

?Each NIC on a DHCP server must have a manually configured IP (ISP assigned and/or Intranet reserved). The DHCP NIC IPcannot be part of the leased scopes.

?If you have a routed network, a single DHCP server can service multiple subnets, but only if your routers are configured as DHCP relay agents. The DHCP server can only assign one scope to each subnet.

Hopethis helps. Best of luck!

by jayesh_nishane

The solution to the problem is that Windows NT service pack 6.0 is to be loaded on after starting DHCP server services. If you start the DHCP server services after loading service pack 6.0 the same problem exists.

This discussion is closed to new replies.