Question Locked

DL 380 GII needs LPT port

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all, I have a question I hope someone can help me with. I have a Compaq DL 380 GII server running Windows 2000 that does not have a printer port. My developers have purchased a dongle that needs a parallel port to work. I bought a PCI parallel card for it but I cannot get the card to work. I can load the drivers and recognize the card but when I reboot I get an error that the card LPT port cannot initialize because hardware that the parallel port relies on did not start. I cannot figure out what hardware is being referenced. I have checked the IRQs, verified everything else is working, the box is fully patched and up to date, I am not sure what is wrong. I have googled for days but I cannot find the answer I am looking for. I did install a USB card yesterday and I was unable to use that device either.

Both cards worked fine yesterday in an XP workstation I had laying around to test them with so I know the cards are good.

The cards are mounted in the server on a riser that I cannot find any switches for and the power light is illuminated on the riser. I find in unthinkable that they just don?t work by design. Any suggestions to what I am doing wrong or missing???

8 replies

by kenone

Did you enable it in the BIOS?
I forget the settings at this moment but I remember setting up Parallel ports in the bios.

by toreador

Other than the PCI IRQ settings I cannot find any other settings in BIOS that would relate to this issue.

by kenone

Mine is under Peripheral Configuration, then Parallel Port. It can be enabled or disabled and I can set Mode, Base Address, Interupt, DMA, etc.

by toreador

Every BIOS is different. The difference here is that I have a server that doesn't have a parallel port so it doesn't have a BIOS setting to turn it on/off. Servers are generally different from PC's.

Thanks!

by ic-it

There is a setting to control the PCI ports. Also consider that two of the ports are hot swappable and only provide 3.3V. The other is standard and has 5V. Here is a clip from the RBSU menu and a link to the pdf.

NOTE: Only IRQs that are modified in RBSU retain the change during the next reboot. IRQs on
PCI devices that have not been modified are subject to change during reboot.
IMPORTANT: When the PCI Hot Plug driver is installed on servers with Microsoft? Windows?
2000 or Windows Server? 2003, disabling a single PCI controller also disables all
controllers on the same PCI bus. To avoid disabling other controllers on the bus, remove the
single PCI controller.

http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c00191707/c00191707.pdf

by toreador

Thanks! When I was doing trial and error setting up the parallel card guess which two ports I tried. Yep! the two 3.3 volt ones. I moved the card into the 5 volt slot and VIOLA! it works now.

Thank you!

This discussion is closed to new replies.