Discussion Locked

HDD Imaging, users, and applications

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to start using Ghost in our IT Dept. for deployment. SInce there are a number of people out there that have used ghost, this is what I want to do:
1. Install base OS and patches under admin account
2. Install all network printers and shares.
3. Install all common user applications (ie.. Office )
4. COnfigure all network settings for dial up and lan.

I want to do all of this logged in as admin. Then as the pc is assigned, the SID would be changed and the pc name would be changed.

Then as the user's got their pc's all they have to do is log in and all of the printers, aps, and shares would be available to them.

Is this totally possible??

THanks for the input,

Chris

7 replies

by still_learning

You will be able to get most of what you want. First you do not run ghost from Windows, and so you cannot be logged in as Administrator. I believe this also means that network devices such as printers and shares will not be available. Hope this helps.

by q2ggirl

I think you have the wrong concept for using ghost. In order for it to benefit you, you will have to start with a HD with all of the printers and applications that you want on there. It's best that the all of the hardware, motherboard have the same configuration as far as the NIC, Video card being in the same slots for every computer so Windows doesn't have to find all the HD again.

After you get a HD loaded with everything that you need on there, you will need to use a bootable disk to boot the computer up and then use the ghost disk to actually ghost the HD.

I hope this gives you a better understanding of what ghost is used for. No matter what user you are logged into to install all of the applications on the HD, that user will not be logged in on the images, the client will still prompt you to login.

Good luck.

by bob the builder

You have the right idea about creating the PC with all your apps/drivers. If you use NT4 or W2K create a dummy user with admin rights and login as that user test all your apps etc. Log back in as administrator and remove admin rights from dummy user and then copy dummy user profile to default profile. I take it you have put an IP address in and put it on the network and tested intranet/internet. Have you put it in the domain? If so then when you are happy remove the PC from the domain and change the IP for a dummy IP and dummy computername (call it CHANGE_ME). When you are happy with this, clone the HDD. I say clone because if you use Norton Ghost you must pay for a client licence per PC. You could always buy a dedicated HDD cloning machine. When you clone the image back remember the images on the new PCs will have the same Computer Name and dummy IP so while the PC is off the network change them. When a new user loggs in they will get the default desktop. If you create a W2K image then when you change any hardware, Plug&Play will kick in and update the drivers (probably). You could create a network share for driver updates and point the PCs at this when you are setting up your image.

This discussion is closed to new replies.