Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 3 switches in which 2 cisco 2960 and one is l-3 360 switch and 3 vlans 10,20and 30 and their respective subnet is 10.121.10.0/24,10.120.10.0/24 and 192.168.10.0/24 and make few ports part of more than one Vlan
3 replies
by mansoorsheikh99 Accepted solution
Clarifications
by subashg_subash Accepted solution
Hi mansoor,
First we need to conform your network (eg:your using cisco L2 and Cisco L3.)
If you are using other brand switch means you should check the compatibility for both.
And if you want to make a single switch port member of multiple vlan you can configure the trunk command in your switch please find the command below
#configure terminal
#interface fasteathernet0/2
#switch port mode trunk
check and revert
Subash.Anbalagan
IT
by mansoorsheikh99 Accepted solution
I'musing Cisco L-2 manageable switches only but the problem is that every N.I.C does not support 802.1q tagging while linux os has support of 802.1q tagging .
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies