Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I currently have 2 3com superstack II hubs and 1 3com switch. I have one hub connected directly to the switch and the other hub is daisy chained into the first hub that I just referenced. My desire is to connect the daisy chained hub directly to the switch like the first one is. I tried a crossover cable which did not work.
5 replies
There's nothing more to do: Use a cross-connect or a crossed port....Or you could check the speed of the port and make sure they match or manually set the port speed...
It could be that you are connecting two hubs to a switch and connecting the same computer to the two hubs, in which case spanning-tree protocol would turn off one port in order to avoid loops...
by poindexter
Thanks for shedding further light on this issue for me.
by scottdo10
What 3com switch are you trying to connect into? Some 3com switch ports (such as in the Superstack Desktop Switch) are made for One device connections unless you are using the Uplink 10/100 ports.
by poindexter
I am going to have to consult the documentation as to the status of the ports on my switch. Thanks the info.
by poindexter
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies