Discussion Locked

How do I load DOS from a Server Console?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running Novell Small Business Suite 5.1 and want to access DOS from the Server Console, How can this be done?

7 replies

by bill_w

Well, the bad news is that you can't really access DOS from the server console. What you can do is load a utility that will allow you to access the server volumes with DOS-like commands, ie copy, dir, delete, etc.

The best one is the "toolbox" utility, get it from support.novell.com. To use it, just "load toolbox" (actually, for 5.1 just toolbox should do if you've put it in sys:system); then tools to get the commands.

A very useful utility, BUT it can get you into trouble very quickly if you're not careful.

Another older one is JCMD, but never tried it with 5.x - Toolbox is OK with Netware 5.

Good luck.

Bill

by jimbb

Don't know for sure about SBS, but the "real" NW5.x comes with Netbasic:
LOAD NETBASIC
and then type
SHELL
Which will give you a DOS-like interface. Good enough to copy, delete or rename a file, things like that. To exit the shell type EXIT.
Jim

by charlese

And if you are looking to edit a file, you can use edit.nlm and just specify the file (i.e c:\autoexec.bat).

This discussion is closed to new replies.