Have a wireless IP Wireless Camera (EasyN FS-613B). Trying to access it through a DLink DIR-615 router. Used the included setup software to identify the cam after following the setup procedure by connecting it to the router via a LAN cable. The software identified the unit with IP address, HTTP Port, Access IP (same as identified IP address) and I tried to access the cam using the IP address the software identified (192.168.1.216:81) but my browser cannot access it to go through the next step in the setup. process to access it via the Internet. Tried this operation with two networked computers with same outcome. I even tried to get the supplied cam setup software “wizard” to gain access but it indicates inability to access with words:”The IP Camera cannot be accessed” and “Please check the Internet”! I tried to play with the router port forwarding table putting in the identified camera IP address along with port 81 and several other things but still can not gain access to the camera using the “identified” IP addresses so I can do the next steps to configure the camera so i can “see” it on the (external) Internet. Any suggestions would be appreciated.