Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have multiple W2K servers each with Terminal Services Remote Admin installed and enabled. How can I connect from my home PC to Administer any of these server? I specify the IP address of the NIC that is connected to the ADSL line, but how do I gain access to the other servers in the network? Do I need to establish a VPN connection to each?
5 replies
by jkuespert
A very simple method would be to use the server exposed to the Internet as a gateway. Install the TS client on the server, connect to the server from home, and point the server's TS client to your internal servers.
by wil
While that is a good suggestion, it does not accomplish the security controls I desire. I want each admin to control his/her own server on their own domain, but not have access/control of the ISA (gateway) server.
by acattr
Each server must be available on the internet for you to access them individually, or use VPN. I like to raise my resolution, terminal into one, and from that one terminal into the other.
One cool tool you can install on your Terminal Server is the "terminal server advanced client"
http://www.microsoft.com/windows2000/downloads/recommended/TSAC/default.asp
It allows you to connect to your server from any machine by using IE and inputing http://ServerAddressOrName/tsweb.
Good Luck.
by wil
Two good suggestions. I will try to implement VPN access as well as incorporate the browser interface.
by wil
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies